Website copyright filing certificate
No data
How to install compact board?
Release time:
2024-12-17 17:55
（1）Measure the wall. This is the first step in installing the cladding wall. Only after accurately measuring the wall can it be calculated how many wall panels are needed, both solid and panelized.
First of all, the length and width of the wall are measured, and the integer number of wall panels required is calculated according to the size of the wall panel, and the excess space can be completed with the wall panel, and the panel should be allocated at the end.
（2）Install the baseboards. The baseboard protects the wall very well, so this is a very basic step in the installation procedure of compact wallboarding. Generally speaking, you should first drill holes in the wall and fix the baseboard hooks to the wall with expansion screws or steel nails.
The hook hole is 7.8cm away from the ground, a hook is fixed every 60cm, and then a baseboard with one end that has been machined at a 45° angle is hung on the hook. In areas with high humidity, where two baseboards are combined, appropriate expansion joints must be set aside, especially in the corners of the wall where furniture is placed, and expansion joints should be considered more.
（3）Install wall-mounted panels. After the above two steps, we will carry out the installation of the wallboard. First of all, slowly insert the anti-compact wall panel from left to right into the finished baseboard, and then install expansion screws or steel nails on the top of the wall about 1.5cm (in the middle of the board width). As a reminder, the nails cannot be exposed during the installation of the wall panels. In the construction, the power switch can be chiseled out with a chisel slightly smaller than the switch, and the positive angle can be used when encountering the column. Apply special glue in the groove of the waist line, and insert it into the concave and convex surface after a few minutes, and the corner of the wall must be 45° diagonal.
（4）Install the top corner. The top line, also known as the shadow line, refers to the boundary between the wall and the ceiling. The usual way to deal with this corner line is to apply a special glue to both sides, then glue it to the top corner, pull it apart for a few minutes, and then stick it tightly. It should be reminded here that the installation must keep the wall clean and dry, so as not to affect the installation effect.
Previous Page
Previous Page
Home Page \ Hospital Wall Panel \ Antibete \ Outdoor board \glass fiber board \ Toilet partition \ Lockers\CNC Machining \ About Lijie \ Site Map
Shenzhen Lijie
Address: No. 24, Yonghe Industrial Park, Dahe Village, Henggang Liuyaohe, Longgang District, Shenzhen
The 24-hour service hotline is the same as WeChat: 13714754418
WeChat Sweep
©2024 Shenzhen Lijie Plate Co., Ltd. website construction:new network Seo Tags